Branch Indicator

  • You are here: S&P United Kingdom



Related System

S&P Asphalt reinforcement

Fibre reinforcement grids for asphalt surfaces

S&P Carbophalt® G 200/200

S&P Carbophalt® G 200/200

S&P Carbophalt® G 200∕200 is a pre-bituminised asphalt reinforcement grid made of carbon fibres for local and/or complete surface reinforcement of bituminous surfaces.

S&P Carbophalt® G 200/200

Call to Action

Pin status

This page is not pinned. Pin this.


  • Measurable improvement of the structural value due to high tensile strength at small elongation
  • Minimises crack formation and prevents crack reflection
  • Prevents fatigue cracks
  • The pre-bituminisation guarantees the required layer bonding between old and new road surfaces (no fixed knots)
  • Lower consumption of tack coat thanks to the pre-bituminised grid
  • Easy and efficient application with unrolling equipment (also in curves)
  • No waiting time - immediate road construction possible
  • Can be milled and recycled without problems
  • Reduces maintenance costs


  • Increases the load bearing capacity of asphalt surfaces
  • Surface reinforcement on roads where the layer height is limited
  • Local application on existing cracks/joints or complete surface application
  • Effectiveness at a cover layer of min. 2 cm

Call to Action

Pin status

This page is not pinned. Pin this.


Contact person


International Product Information

Data Area

Product Information

We appreciate your interest. Take a look at the data. If you have any questions or need help, please contact us.

Logistic Data

    • Delivery
      Width of roll1.95 m (further on request)
      Length of roll50 m

Installation Instructions

  • - Apply S&P Carbophalt® G 200∕200 on dry surface, either by machine or manually, and if possible immediately before the installation of the road surface
    - Apply at temperatures > 3 °C. Observe relevant norms for application of layers
    - Ensure overlapping lengths of 10–20 cm are observed
    - Overlapping of the reinforcement mesh should be optimised, according to the nature and location of joints/cracks, as well as wheel loading
    - If the mesh is applied only on local areas, it shall be covered manually with an asphalt layer. This prevents cracking caused by passing vehicles.
    - Minimum covering of 2 cm above S&P Carbophalt® G 200∕200

    Unrolling equipment is available on a rental basis. S&P will assist and/or carry out the work if requested.

You are here



    SIMPSON Strong-Tie

    Meta Navigation en-GB