FX-70 System
Repair and protection of piles (underwater and dry applications)
Related System
FX-763CTG
FX-763CTG
FX‑763 Low-Modulus Non-Sag Epoxy Cartridge is a two-component, 100% solids, moisture-tolerant, non-sag epoxy designed for vertical, horizontal, and overhead applications and uses.
Call to Action
Features
- Bonds well to most construction materials
- Bonds to dry or damp surfaces
- Excellent chemical and abrasion resistance in wastewater and other industrial applications
- Can be feather edged
- Easily applied
Application
- Joint repairs
- Vertical, horizontal and overhead crack sealing
- Securing ports and paste-over for pressure injection applications
- As a jacket joint sealer and top-bevel material for the FX‑70®
- Structural Repair and Protection System
Call to Action
Service
Contact person
Documentation
-
Technical Data Sheet FX-763CTG
-
Safety Data Sheet FX-763CTG (Component A)
-
Safety Data Sheet FX-763CTG (Component B)
International Product Information
-
We provide international product information on our portal S&P International.
Data Area
Product Information
We appreciate your interest. Take a look at the data. If you have any questions or need help, please contact us.
Logistic Data
-
Storage Store dry beteen 4 - 35 °C Shelf Life 2 years in unopened packaging Packaging 425 g dual cartridge
Safety Data
-
For detailed safety information it is recommended to seek advice in the current safety data sheet.
Installation Instructions
-
For anchor grouting/doweling/pinning:
Fill hole 1/2 to 2/3 full. Insert clean, oil-free anchor, turning slowly until the anchor contacts the bottom of the hole. Do not disturb anchor until fully cured (see cure time schedule).General Concrete Repair/Adhesive:
Apply properly mixed FX‑763 Low-Modulus Trowel Grade Epoxy to the prepared substrates. Secure in place until fully cured.Crack Injection Paste-Over/Port Adhesive:
Apply properly mixed FX‑763 Low-Modulus Trowel Grade Epoxy to the surface of injection ports and adhere the ports to concrete surface. After ports have set, seal the entire crack by applying FX‑763 Low-Modulus Trowel Grade Epoxy with a putty knife at a minimum thickness of 5 mm and 25 mm wide over the crack. Cover all ports with a minimum thickness of 6 mm and extend 25 mm beyond the base of the port. If possible, seal the backside of the crack. Allow FX‑763 Low-Modulus Trowel Grade Epoxy to fully cure before injecting. FX‑763Low-Modulus Trowel Grade Epoxy can be applied to (SSD) concrete. Do not apply to wet concrete surfaces. All other surfaces must be dry. Do not apply in direct sunlight and protect from large temperature variations for 24 hours following installation.
Products
FX-70 System
Repair and protection of piles (underwater and dry applications)
